[pperry1966]

How hard was it to apply? I was thinking it would be hard to get the bubbles out when you are going over the GS part of the tank. It was a little difficult installing the decals on my bags because of the indentations for the BMW logo. I used a heat gun and poked pin holes in it to let the air out. The bag decals are really thick, I'm not sure if that makes them easier to install or harder? It's much easier applying a decal over a flat surface on a bag than the curved surface of a tank.

I haven't got them yet, but yes, the curves are going to be the biggest challenge

 

[pperry1966]

Got them in the mail the other day, and I've got to say it looks a little intimidating to bordeline butt puckering. Gonna wait till it warms up before I try applying them so hopefully it will be easier.

 

[Robertg]

I've applied graphics with soapy water and a squeegee before. I think they want these applied dry? Good luck because you might need it.