[Math]

Removed frame , its looking abit tatty, it was buried well in the bike but finally came out, so off to the shot blasters, then a repaint,

 

[Math]

Paint or powder coat ?

Back from shot blasters , im wanting to paint it, so i can rub down stone chips and spray and touch up again, some things iv powder coated like the centre stand, because there easily removed the clean back up

 

[Math]

View attachment 34536 Back from shot blasters , im wanting to paint it, so i can rub down stone chips and spray and touch up again, some things iv powder coated like the centre stand, because there easily removed the clean back up

 

[Math]

 

[Math]

Once iv got front built im removing rear frame

 

[Math]

Thats the frame and oil cooler back in

 

[Math]

Thank you, i like to go right through the bikes then i feel confident about taking them exploring , there very good on trails, i have videos on my youtube account

 

[Math]

Thats a bit more removed, swing arm out and bearings looked bad so ill be replacing them

 

[Math]

 

[Math]

Thats frame removed and stripped ready for shot blasting, are these frames galvanized before coating? Do you prefer powder coat or paint? Im thinking painting

 

[Math]

Thats a relief

 

[Math]

Todays project is to tidy up the flaky paint

 

[Math]

 

[Math]

Im on with another project, im building my new table for a engine strip down, ill be doing a detailed strip, and videoing it for my youtube channel

 

[Math]

Thats the frame back from painters

 

[Math]

Frame back in now

 

[Math]

Jobs done today, new side stand bushes fitted, side stand bolt cleaned groove for clip that holds switch , slave cylinder fitted, inlet rubber boots fitted, rear brake switch fitted, gear selector linkage fitted and gear selector bushes fitted

 

[Math]

Frame back in

 

[Math]

 

[Math]