R1200GS Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
54 Posts
Discussion Starter · #1 ·
I am 1800 miles from the last oil change. Right after the oil chance, the oil level was ~1/8'' below the top of the circle, now it's about 1/3 down from the top (see picture). Anyone notice the same with their 1250 GS. It's a 2020 model with 6300 miles.
 

Attachments

·
Registered
Joined
·
54 Posts
Discussion Starter · #4 ·
If you're changing the oil and filter, are you guys putting all 4 quarts back in? That fills mine to the top of the sight glass and I went the longest I've ever gone on an oil change with this last one(about 6K miles) - level was about 3/4 on the sight glass.
It sound like there is some oil consumed on that bike as well. BMW boxers are known to consume some oil, so I am not sure it's necessarily a catastrophic failure, but was just curious to know if other experience this on their 1250 GS. I also read that in some cases, the oil consumption is reduced or disappears after 10K + miles. Time will tell....
 

·
Registered
Joined
·
54 Posts
Discussion Starter · #7 ·
If you let your boxer sit on the side stand for a long period of time, some oil will leak down and get burned off when you crank it. Nothing to worry about but seeing some blue smoke when you're not expecting it might surprise riders.
The only time the bike is on the side stand is during gas station stops on day rides. Normally, it is on the center stand when stored in the garage. I did notice white smoke coming out of the exhaust during the first few minutes after starting her up in the morning.
 

·
Registered
Joined
·
54 Posts
Discussion Starter · #11 ·
If your bike does not require any oil to be added between oil changes then I wouldn't characterize that bike as "using/burning oil." All engines burn a tiny amount of oil. To the OP, did you crank the bike and let it circulate into the oil filter after the oil change before witnessing that it was only 1/8" down from the top of the sight glass?

I don't put any oil in my new filter before installing it so I add the full 4 quarts and after cranking it and letting it run for a bit, then checking it, it's no longer at the top of the glass.
Yes, I did let the engine run after putting the new filter and than added some oil until it reached the top of the circle. Now, about 2K miles after the oil change, the oil level is down to about the middle of the circle.

Would riding style have an impact on how much oil is "burned up" ?
 
1 - 4 of 4 Posts
Top