R1200GS Forum banner
21 - 32 of 32 Posts
Discussion starter · #21 ·
Now glue it to the bike.
I used anti corrosion grease on the nipple , seems fine ... The glue would be a bit difficult I feel , also now aware I will be easier with the handling , I feel the rubber and nipple stick to each other with the grease I hope no seal is made..

If I lose it again , I will come back to this thread and say what a dummy I am :surprise::laugh2:
 
I used anti corrosion grease on the nipple , seems fine ... The glue would be a bit difficult I feel , also now aware I will be easier with the handling , I feel the rubber and nipple stick to each other with the grease I hope no seal is made..

If I lose it again , I will come back to this thread and say what a dummy I am :surprise::laugh2:
How dare you take other peoples suggestions over mine.....Communist. :smile2:
A little rubber cement on a toothpick inside the groove in the rubber o-ring, simple.
 
21 - 32 of 32 Posts